Disclaimer

Delform does not recommend the use of STEEL where its application will be in frequent contact with moisture or where abrasion is likely (i.e. clothing hang bars, counter tops, toe-kick/ floor base, handrails, foot rails, etc.), and is not responsible for corrosion or damage should this recommendation not be followed. Delform recommends all welding, assembly, shearing, brake-forming, etc. be performed prior to finishing to maintain the finish and integrity of the lacquer, and installation should occur after all other trades to protect the finished product. On-site touch-ups or refinishing will be the responsibility of buyer/installer and is not included in Delform’s scope of work.

Should protection be needed during handling and/or installation, Delform does not recommend the use of any type of adhesive sheeting. Please ONLY drape plastic over the finished components and, if necessary, secure with 3M tape recommended for *delicate* surfaces. DO NOT leave tape on longer than recommended by tape manufacturer [max 24 hrs] as this may cause damage to the lacquer.

Please only clean the finished product with approved cleaners [mild soap & water] recommended by our lacquer manufacturer, Peacock Labs. This information can be found on our website under “Maintenance” tab. or at Permalac.com. Do NOT use ammonia based, solvent based, or abrasive based cleaners or rags.

Delform assumes no responsibility should the finish or lacquer be compromised from misuse.

Delform offers no warranties expressed or implied; however, we make every effort to ensure that our clients are happy with our products.